Flow rate limitation in open wedge channel under microgravity

A study of flow rate limitation in an open wedge channel is reported in this paper. Under microgravity condition, the flow is controlled by the convection and the viscosity in the channel as well as the curvature of the liquid free surface. A maximum flow rate is achieved when the curvature cannot balance the pressure difference leading to a collapse of the free surface. A 1-dimensional theoretical model is used to predict the critical flow rate and calculate the shape of the free surface. Computa- tional Fluid Dynamics tool is also used to simulate the phenomenon. Results show that the 1-dimensional model overestimates the critical flow rate because extra pressure loss is not included in the governing equation. Good agreement is found in 3-dim- ensional simulation results. Parametric study with different wedge angles and channel lengths show that the critical flow rate increases with increasing the cross section area; and decreases with increasing the channel length. The work in this paper can help understand the surface collapsing without gravity and for the design in propellant management devices in satellite tanks.     

Research on speckle noise of laser Doppler velocimeter for the vehicle self-contained navigation

A novel multipoint layer-type laser Doppler velocimeter (MLLDV) is designed to measure the velocity of a vehicle for the self-contained navigation system. In order to investigate the speckle's influence on the Doppler spectrum, formulas of time-lagged covariance and speckle broadening were derived for our MLLDV. Simulations and experiments are made for detailed analysis. The results show that the time-lagged covariance of photocurrent is directly proportional to the incident angle, and is inversely proportional to the elevation fluctuation of the ground together with the velocity of the vehicle. Speckle broadening is a function of the vehicle's velocity, the 1/e² Gaussian spot radius and the phase correlation length of the ground. For our MLLDV, Doppler frequency and Doppler broadening are both directly proportional to the velocity of the vehicle. Besides, the ratio between Doppler broadening and the corresponding Doppler frequency is about 0.72% when the speed of the vehicle varies from 0 to 9.6 m/s.     

Passive neutron area monitor with pairs of TLDs as neutron detector

A passive neutron area monitor has been designed using Monte Carlo methods; the monitor is a polyethylene cylinder with pairs of thermoluminescent dosimeters (TLD600 and TLD700) as thermal neutron detector. The monitor was calibrated with a bare and a thermalzed ²⁴¹AmBe neutron sources and its performance was evaluated measuring the ambient dose equivalent due to photoneutrons produced by a 15 MV linear accelerator for radiotherapy and the neutrons in the output of a TRIGA Mark III radial beam port.     

Measurements of decays into and

Based on a sample of 5.8×10⁷ J/ψ events taken with the BESII detector, the branching fractions of J/ψ→2(π⁺π⁻)η and J/ψ→3(π⁺π⁻)η are measured for the first time to be (2.26±0.08±0.27)×10⁻³ and (7.24±0.96±1.11)×10⁻⁴, respectively.     

中、远红外双波段激光器发射光谱测量与评估

在分析中远红外双波段(氟化氘与一氧化碳)激光器发射光谱的基本特征和分光型谱仪存在高级次光谱混叠等问题的基础上,选定Tensor37干涉型遥测光谱仪并利用黑体标定出仪器响应函数;对中、远红外双波段激光器光谱进行了模拟测量和实际测量,分析评估了双波段激光器的谱线成分、峰值变化、测量精度和相对强度等,为双波段激光器的介质参数计算、运转参数优化以及红外应用提供有效数据。     

A device for aerosol charge measurement and sampling

In this work, a device for aerosol charge measurement and dust sampling is presented. The device is basically an open-ended Faraday pail with a filter to collect the sample. It can be attached to a pneumatic transfer line or it can be used with hose, depending on the situation. When the system was developed, special emphasis was put on the ease of use and reliability. The device can be assembled and disassembled with one twist. The reliability and the operation of the device was tested using two different powder materials, test dust and polystyrene pellets, and four different hose materials. By combining these materials, different extents and polarities of tribo-charge were obtained. The device proved to be easily operated and the test results showed good reproducibility.     

Sub-200 fs microjoule pulses from a monolithic linear fiber CPA system

An all-fiber-integrated linear chirped-pulse amplifier system generating microjoule pulse energies is reported. It is seeded by an all-fiber dissipative-soliton laser and incorporates a newly developed fiber stretcher, whose dispersive properties match that of the grating compressor. Pulse durations of 189 fs with energies of 2.2 μJ were achieved after compression. The average power was 9.8 W at the repetition rate of 4.5 MHz.     

Induced electric fields and plasmonic interactions between a metallic nanotube and a thin metallic film

We have numerically simulated the induced electric fields and the plasmonic interactions of a metallic nanotube near a thin metallic film. Our study shows that the energies and intensities of the plasmon resonances depend strongly on the aspect ratio (the ratio of the inner to outer radius) of the nanotube as well as the separation between the center of the nanotube and the upper surface of the metallic film and the thickness of the film. The enhancement of the induced electric field of this system reaches ...     

A new graphical coding of DNA sequence and its similarity calculation

The DNA primary sequence is translated into “structure graph” based on classification of its four bases. Then the invariants, such as topological indices, are extracted from those graphic representations of DNA primary sequences, and used to calculate the similarities among the eleven species. From these similarities/dissimilarities the homologies can be revealed that they are in agreement with evolutionary relation satisfactorily.